APOLITON 350.2
OUR PRODUCTS
FEATURES
The Apoliton 350.2 is a powerhouse, 2-channel analog masterpiece designed by the same ultra-high-end audiophile brand Apoliton. While sharing the exact same purist engineering DNA as the 200.4, it shifts its focus from multi-channel setups to delivering massive stereo power to demanding front-stage mid-bass drivers or high-fidelity subwoofers.
It utilizes the “HyperCon” power supply.
The electrical performance scales up significantly to provide serious headroom while maintaining flawless transparency.
The core strengths and features of the Apoliton 350.2 car audio amplifier center on purist audiophile engineering, extreme signal speed, and massive power delivery. It prioritizes internal component quality over external aesthetic gimmicks.
Differences to the 200.4
- Target Application: While the 200.4 is designed to run active 2-way component sets (tweeters + midranges) or an entire cabin, the 350.2 acts as a dedicated heavy-lifter. It is typically bought to run power-hungry 8-inch mid-bass door speakers, massive passive 3-way front stages, or a high-end SQ subwoofer.
- Brute Strength: It jumps from 200W to a staggering 380W per channel at 4 ohms, giving you virtually unlimited headroom so your speakers never experience clipping or compression during dynamic musical peaks.
The Apoliton 350.2 is one of the most powerful sound-quality-focused 2-channel amplifiers on the market. If you want a sub-bass or mid-bass response that is incredibly tight, authoritative, and completely uncolored by distortion, this amplifier has few rivals.
When bridged, the Apoliton 350.2 car audio amplifier delivers a massive 1 x 1150W RMS into a 4-ohm mono load. This configuration converts the 2-channel high-fidelity stereo amplifier into a singular, ultra-powerful mono block optimized for driving demanding subwoofers or heavy mid-bass arrays.
SPECIFICATIONS
State of the art HyperCon switch mode power supply
Operating Voltage 10-16V
Input Sensitivity 0.9-10Vrms
Input Impedance 10KΩ
Power output @4Ω 2 x 380Wrms
Power output bridged @4Ω 1 x 1150Wrms
Frequency response @-3db (protection disabled) 0.6Hz-75KHz
20Hz-20KHz deviation +/-0.15%
Slew rate (amplifier section) >200V/μsec
THD at 4Ω/1Wrms <0.01%
Output noise (no load connected) 24mV
Idle current (after warm up) <2.5A
Maximum current draw @4Ω 80A
Maximum current draw @4Ω bridged 140A
Internal HSB fuse 80A
Independent gain control for each channel.
Flow design referenced to the signal path
Direct Drive capability that allows preamp bypassing
DC protection
Thermal protection (amp shuts down at 72 degrees Celsius)
Dimensions W 485mm, D 244mm, H 72mm
Net Weight 9Kg
CE Certification
2 years warranty to the original owner
Lifetime warranty for the software
*We preserve the right for alterations.